Mailing Address:
VIRxSYS Corporation
200 Perry Parkway, Suite 1A
Gaithersburg, MD 20877
Phone: 301.987.0480
Fax: 301.987.0489
E-mail: findout@virxsys.com
Directions to VIRxSYS Corporate Office
Get directions from MapQuest.
From BWI Airport:
Depart BWI I-195 W. Take MD-295 S (Exit 2B) Baltimore Washington Parkway towards Washington. Take the I-95 N/I-495 N exit towards Baltimore to get onto the Washington Capital Beltway. Take the I-270 N exit number 35 towards Frederick to merge onto I-270 N. Take Exit 10 for Route 117 Clopper Road/W. Diamond Avenue. Turn LEFT at the light at the bottom of the exit ramp onto Route 117. At the first intersection, turn LEFT onto Perry Parkway. Turn LEFT into the first driveway and make an immediate LEFT once in the parking lot to pull in front of VIRxSYS building. Building number 200 suite 1A is at the end of the parking lot on the right.
From Reagan National Airport:
Proceed out of the airport to the George Washington Memorial Parkway - North. Go to the end of the Parkway and take the I-495 North exit towards Maryland to merge onto the Washington Capital Beltway. Take the I-270 exit number 38 (exit on the LEFT) towards Rockville/Frederick. This will merge onto I-270 spur, which will take you to I-270 N. Take Exit 10 for Route 117 Clopper Road/W. Diamond Avenue. Turn LEFT at the light at the bottom of the exit ramp onto Route 117. At the first intersection, turn LEFT onto Perry Parkway. Turn LEFT into the first driveway and make an immediate LEFT once in the parking lot to pull in front of VIRxSYS building. Building number 200 suite 1A is at the end of the parking lot on the right.
From Washington Dulles International Airport:
Proceed out of Dulles International onto the Dulles Airport Access Road towards the Washington Capital Beltway. Take the VA-267 E exit 12-13-14 towards Reston, Wiehle Avenue, Hunter Mill Road. Merge onto VA-267 E (Portions toll). Take I-495 exit 18- towards Baltimore/Richmond. Keep LEFT at the fork in the ramp. Merge onto Capital Beltway. Take the I-270 exit number 38 (exit on the LEFT) towards Rockville/Frederick. This will merge onto I-270 spur, which will take you to I-270 N. Take Exit 10 for Route 117 Clopper Road/W. Diamond Avenue. Turn LEFT at the light at the bottom of the exit ramp onto Route 117. At the first intersection, turn LEFT onto Perry Parkway. Turn LEFT into the first driveway and make an immediate LEFT once in the parking lot to pull in front of VIRxSYS building. Building number 200 suite 1A is at the end of the parking lot on the right.